Whelen 9061303 Uživatelský manuál stáhnout pdf

Page 1

ENGINEERING COMPANY INC.

51 Winthrop Road

Chester, Connecticut 06412-0684

Phone: (860) 526-9504

Fax: (860) 526-2009

Internet: www.whelen.com

Sales/Service e-mail: [email protected]

Aviation

Installation Guide:

Aviation model 9061303, 9061304

P/N 01-0790613-03, 01-0790613-04

LED Position and Anti-Collision

Light Assembly

Form No.14445A (053112)

SPECIFICATIONS:

Nominal Operational Voltage:............................... 28 VDC

(Operation from 22-32 VDC)

Input Current:

LED Position Light .....................................................0.23 Amps

LED Anti-Collision Light (Avg.) .................................0.73 Amps

LED Anti-Collision Light (P[email protected] Sec.) ..............3.9 Amps

Flashrate.......................................................................45 ±5 / Min.

EQUIPMENT LIMITATIONS:

An approved lighting system consists of two lights, one located on each

wingtip. The baseplate must be mounted parallel to the vertical and

horizontal centerlines of the aircraft to project the patterns properly.

Certain types of installations may require additional testing.

CONTINUED AIRWORTHINESS:

The forward position light is designed with 4 Green LEDs or 5 Red LEDs.

The tail position light is designed with 2 LEDs. The anti-collision light is

designed with 36 LEDs. If any one LED fails, the unit must be repaired or

replaced. Note: To reduce eye strain, use an optical filter such as dark

glasses or a blue covering dome during LED inspection. Inspect the lens.

Replace if there is excessive scratching, pitting, discoloration or

cracking.

Note: The anti-collision light will automatically shut-off after 9-10 flashes

if a failure is detected.

INSTALLATION PROCEDURES:

The following information is to assist you in installing a Whelen light

system. The installation procedure described in the following text will be

confined to a single light installation, but is identical for multiple light

installations.

1. Choose the appropriate Model 90613( ) light assembly.

2. Using the mounting detail information provided, prepare the aircraft

for means to secure the LED light assembly.

3. Connect the inputs according to the chart shown. Connect the

power leads to an appropriately sized breaker. Connections to be in

accordance with FAA approved methods.

4. Remove the lens retainers and carefully remove the lens. Using

appropriate hardware, install the light assembly and insure that all

leads are clear of any obstructions. Secure as required. Secure the

light assembly using vibration resistant threaded fasteners.

5. Carefully reinstall the lens and retainers.

6. Waterproof the lightbase to aircraft. Apply single-part Silicone

(RTV) or equivalent around any open area where water could get

in.

7. Check all avionics systems for interference from this installation.

8. A flight check should be performed by a properly certified pilot.

9. Update aircraft records, complete Form 337 and obtain FAA

field approval for installation, as required.

Note: SYNC is a low power bi-directional control signal. Connecting

to the synchronize signal of any Whelen LED anti-collision

assembly will cause the lights to flash at the same time. If

syncronization is not necessary, the connection may be left open.

MADE IN THE U.S.A.

The conditions and tests required for TSO approval of this

article are minimum performance standards. It is the

responsibility of those installing this article either on or within

a specific type or class of aircraft to determine that the aircraft

installation conditions are within the TSO standards. TSO

articles must have separate approval for installation in aircraft.

The article may be installed only if performed under 14 CFR

part 43 or the applicable airworthiness requirements.

TSO-C30c

TYPE I, II & III;

APPROVED

TSO-C96a

CLASS II;

APPROVED

PIN 1

PIN 2

PIN 3

PIN 4

WHT

RED

YEL

BLK

+28V POSITION

+28V ANTI-COLLISION

SYNC

GROUND

CONNECTOR WIRING

.25

2.01

3.81"

5.61

1.77

20AWG WIRE

MIL-W-22759/43

6.00" ± 1.00"

1 2

Shrnutí obsahu

Strany 1 - Aviation

Page 1®ENGINEERING COMPANY INC.51 Winthrop RoadChester, Connecticut 06412-0684Phone: (860) 526-9504Fax: (860) 526-2009Internet: www.whelen.comSales/Se

Strany 2 - ITEM PART NUMBER DESCRIPTION

Page 2441111111ITEM PART NUMBER DESCRIPTIONASS'Y, GREEN POSITION / A-C LIGHTASS'Y, RED POSITION / A-C LIGHTRETAINER, REARRETAINER, FRONTSCR

Příbuzné modely 9061304

Komentáře k této Příručce

Žádné komentáře

Whelen 9061303 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Vzduchová zařízení Whelen 9061303. Whelen 9061303 User Manual Uživatelská příručka

Shrnutí obsahu

Příbuzné modely 9061304

Komentáře k této Příručce

Související produkty a manuály pro Vzduchová zařízení Whelen 9061303